5 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 5 / 5
Yayın Dating fossil root cast (Black Sea coast, Turkey) using thermoluminescence: Implications for windblown drift of shelf carbonates during MIS 2(Elsevier Ltd., 2016-05-16) Polymeris, George S.; Kitis, George; Güneç Kıyak, Nafiye; Theodosoglou, Eleni; Tsirliganis, Nestor C.; Ertek, Topçu Ahmet; Erginal, Ahmet EvrenRhizoliths are mostly sub-aerially exposed root prints which appear through removal of the rock units that cap them. A horizontal-lying residual of a rhizolith, consisting purely of soft inner core material of white color was recovered 10 km west of Şile, Istanbul, in northwest Turkey within laminated oolithic massive aeolianite. The inner part, consisting purely of calcium carbonate, was dated by applying thermoluminescence, while for the outer shelves optically stimulated luminescence of quartz was used for age assessment. The age of the CaCO3 infill occupying the original place of the decayed plant roots was found to be 26.8 (±5.0) ka, corresponding to MIS 2. When compared with the ages of the middle (105.2 ± 15.6 ka) and outer (127 ± 9 ka) layers, corresponding to the later stage of MIS 5e or early stage of MIS 5d, the inner core coincides with the last glacial period when the sea-level was lower than the present, promoting transportation of ooids by offshore winds in conjunction with the exposed shelf carbonates. Based on the results yielded, rhizolith is much younger than the host rock aeolianite and witnesses to last glacial sea level lowstand when removal of shelf carbonates by offshore winds was promoted from the exposed shallow shelf plain. The results provide strong evidence that rhizoliths may not be coeval with the aeolianites within which they are embedded.Yayın In-homogeneity in the pre-dose sensitization of the 110 degrees C TL peak in various quartz samples: The influence of annealing(Elsevier Science BV, 2012-03-01) Polymeris, George S.; Oniya, Ebenezer O.; Jibiri, Nnamdi N.; Tsirliganis, Nestor C.; Kitis, GeorgeThe pre-dose sensitization effect of the 110 degrees C TL glow-peak of quartz is a basic tool in thermoluminescence and optically stimulated luminescence dating and retrospective dosimetry. In the present work, a homogeneity study was performed on pre-dose sensitization in grains obtained from large quartz crystals samples collected from 10 different origins. The aliquot - to - aliquot scatter of the pre-dose sensitization of the 110 degrees C TL peak within each quartz crystal was monitored. The influence of the annealing on this scattering was also studied. Therefore, the investigation was applied to the un-fired "as is" samples as well as to samples annealed at 900 degrees C for 1 h following cooling to room temperature in air. The results showed that in the case of "as is" quartz the sensitization effect vary strongly within each aliquot of the same quartz sample. This strong variation is removed by both the high temperature annealing as well as heating up to 500 degrees C, involved in the TL measurements. These results are generally discussed in the framework of existing models and applications of the effect.Yayın Investigation of OSL signals from very deep traps in unfired and fired quartz samples(Elsevier Science BV, 2010-03-15) Kitis, George; Güneç Kıyak, Nafiye; Polymeris, George S.; Pagonis, VasilisThis paper presents an attempt to isolate experimentally optically stimulated luminescence (OSL) signals which may originate from very deep traps (VDT) in quartz samples. As VDT we consider those traps which are responsible for TL glow peaks with a peak maximum temperature above a TL readout temperature of 500 C. The basic experimental procedure used to isolate OSL signals from VDT is heating the quartz samples to 500 C immediately before measuring the OSL signal. The study was carried out on eight quartz samples of very different origins; it is found that all eight samples exhibit OSL signals from VDT, and for a wide region of OSL stimulation temperatures. The OSL signal from VDT depends strongly on the type of quartz sample studied and on whether the sample was fired at high temperatures or not. The behavior of the OSL signal from VDT as a function of the stimulation temperature is found to be very different in fired and unfired samples. The thermal activation energy E for the OSL signals from VDT is obtained in both fired and unfired samples. The OSL signal from VDT in quartz samples fired at 800 C for 1 h is very high, and the OSL curves consist of three well-defined components and a fourth slow component which is rather poorly resolved. The dose response of these components is obtained using a computerized deconvolution procedure for the dose region 0.5-300 Gy. The results are of importance for dating of ancient fired ceramics, since OSL signals from VDT could potentially extend appreciably the equivalent dose region toward both lower and higher values.Yayın Temperature lags of luminescence measurements in a commercial luminescence reader(Elsevier Science Inc, 2015-09-15) Güneç Kıyak, Nafiye; Kitis, George; Polymeris, George S.The temperature recorded in thermoluminescence and optically stimulated luminescence equipments is not the temperature of the sample but that of the heating element on which the thermocouple is attached. Depending upon the rate of heating, a temperature difference appears between the samples and the heating element, termed as temperature lag, which could have serious effects on the curve shapes and trapping parameters. In the present work the temperature lag effect is studied in a newly developed luminescence equipment measuring both thermoluminescence and optically stimulated luminescence. It is found that the temperature lag could be large for heating rates above 2 K/s and it is strongly dependent upon the sample holder. A simple approximation method is proposed in order to both predict as well as correct for temperature lag effects in luminescence measurements.Yayın Thermal quenching of thermoluminescence in quartz samples of various origin(Elsevier Science BV, 2011-03-15) Subedi, Bhagawan; Oniya, Ebenezer O.; Polymeris, George S.; Afouxenidis, Dimitrios; Tsirliganis, Nestor C.; Kitis, GeorgeThe effect of thermal quenching stands among the most important properties in the thermoluminescence (TL) of quartz on which many applications of TL are based. Since the quartz samples used in various applications are all of different origin it is useful to investigate whether the values of the thermal quenching parameters, i.e. the activation energy for thermal quenching W and a parameter C which describes the ratio of non-radiative to radiative luminescence transitions, evaluated mainly in specific quartz samples can be extrapolated to quartz samples of unknown origin as well as to quartz samples which are annealed at high temperatures. In the present work the TL glow curve of a series of un-annealed and annealed natural and synthetic quartz samples were studied as a function of the heating rate between 0.25 K/s and 16 K/s. Using an indirect fitting method it was found that the thermal quenching parameters W and C in most of the quartz samples are very similar to the values accepted in the literature. Furthermore, in some cases the thermal quenching parameters Wand Care not the same for all TL glow-peaks in the same glow-curve. Finally, the strong external treatment of annealing the quartz samples at very high temperature can also influence at least one of the thermal quenching parameters.
