3 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 3 / 3
Yayın Numerical investigation of the effect of radial lip seal geometry on sealing performance(IOP Publishing Ltd, 2018) Tok, Görkem; Parlar, Zeynep; Temiz, VedatSealing elements are often needed in industry and especially in machine design. With the change and development of machine technology from day to day, sealing elements show continuous development and change in parallel with these developments. Many factors influence the performance of the sealing elements such as shaft surface roughness, radial force, lip geometry etc. In addition, the radial lip seals must have a certain pre-load and interference in order to provide a good sealing. This also affects the friction torque. Researchers are developing new seal designs to reduce friction losses in mechanical systems. In the presented study, the effect of the lip seal geometry on sealing performance will be examined numerically. The numerical model created for this purpose will be verified with experimental data firstly. In the numerical model, shaft and seal will be modeled as hyper-elastic in 2D and 3D. NBR (Nitrile Butadiene Rubber) as seal material will be analyzed for the rotating shaft state at constant speed by applying a uniform radial force.Yayın Investigation and prediction of surface integrity induced by milling of hot forged and heat treated AA7075(Motto, 2024-11-03) Tok, Görkem; Dinçer, Ammar Tarık; Kuzu, Ali Taner; Bakkal, Mustafa; Saklakoğlu, İ. EtemThis study examines the influence of cutting parameters on surface integrity, focusing on residual stress and surface roughness, in hot-forged and T6 heat-treated AA7075 components post-milling. Using the Taguchi L9 DOE method, orthogonal cutting milling experiments were performed, with residual stress measured via nondestructive X-ray diffraction (XRD). The analysis indicated that lower cutting speeds reduce residual stress, with down milling causing compressive and up milling causing tensile stresses. A proposed model showed a significant correlation between cutting force and residual stress—higher cutting forces increased residual stress. Surface roughness assessment revealed that feed rate greatly impacts residual stress, with lower feed rates reducing roughness. These insights will aid in developing a regression model for predicting outcomes in future experiments, enhancing the understanding and control of surface integrity in milling AA7075 components.Yayın Energy-based characterization of drilling-induced residual stresses in AA7075-T6(Multidisciplinary Digital Publishing Institute (MDPI), 2026-01) Tok, Görkem; Dinçer, Ammar Tarık; Bakkal, Mustafa; Kuzu, Ali TanerThis study examines the influence of drilling parameters on thrust force, torque, active work, and axial residual stress formation in hot-forged and T6-treated AA7075, a critical high-strength aluminum alloy. A full factorial design was applied using three spindle speeds (800, 1000, 1200 rpm) and three feed rates (0.05, 0.10, 0.15 mm/rev). Cutting force and torque signals were measured using a dynamometer, and axial residual stresses were determined by X-ray diffraction at two locations along the hole depth, namely, the hole entrance (Point A) and the hole exit (Point B). The results show that feed rate is the dominant factor influencing drilling mechanics and residual stress formation, whereas spindle speed mainly affects the thermal and frictional conditions governing stress relaxation. A consistent asymmetry was observed between the two measurement locations, with the exit side exhibiting stronger stress relaxation behavior associated with breakthrough mechanics. Finally, the relationship between active work and axial residual stress is discussed using a qualitative, energy-based interpretation, highlighting active work as a physically meaningful indicator for drilling-induced residual stress evolution.
