2 sonuçlar
Arama Sonuçları
Listeleniyor 1 - 2 / 2
Yayın Inductor saturation compensation in three-phase three-wire voltage-source converters via inverse system dynamics(Institute of Electrical and Electronics Engineers Inc., 2022-05-01) Özkan, Ziya; Hava, Ahmet MasumIn three-phase three-wire (3P3W) voltage-source converter (VSC) systems, utilization of filter inductors with deep saturation characteristics is often advantageous due to the improved size, cost, and efficiency. However, with the use of conventional synchronous frame current control methods, the inductor saturation results in significant dynamic performance loss and poor steady-state current waveform quality. This article proposes an inverse dynamic model-based compensation (IDMBC) method to overcome these performance issues. For this purpose, two-phase exact modeling of the 3P3W VSC control system is obtained. Based on the modeling, the inverse system dynamic model of the nonlinear system is obtained and employed such that the nonlinear plant is converted to a virtual linear inductor system for linear current regulators to perform satisfactorily. Further, to control phase currents in the synchronous frame, a two-phase coordinate transformation is proposed. The IDMBC method is tested via dynamic command response and waveform quality simulations and experiments that employ saturable inductors reaching down from full inductance at zero current to 1/9th inductance at full current. The results obtained demonstrate the suitability of the method for 3P3W VSCs employing saturable inductors.Yayın Low-loss active inductor with independently adjustable self-resonance frequency and quality factor parameters(Elsevier Science BV, 2017-06) Köprü, Ramazan; Momen, Hadi Ghasemzadeh; Yazgı, Metin; Saatlo, Ali NaderiThis work presents a new low-loss active inductor whose self-resonance frequency and quality factor parameters can be adjusted independently from each other. In order to achieve this property, a new input topology has been employed which consists of cascode structure with a diode connected transistor. Furthermore, the proposed input topology makes the device robust in terms of its performance over variation in process, voltage and temperature. Additionally, RC feedback is used to cancel series-loss resistance of the active inductor, which allows self-resonant enhancement as well. Schematic and post-layout simulation results show the theoretical validity of the design. To validate the design feasibility for process, voltage and temperature changes, Monte Carlo and temperature analysis are done. Suggested structure shows inductor behavior in the frequency range of 0.3–11.3 GHz. Maximum quality factor is obtained as high as 2.1k at 5.9 GHz. Total power consumption is as low as 1 mW with 1.8 V power supply.
